Customer Reviews and Ratings

3.5 out of 5 stars

Based on 26 reviews

  • 1.0 out of 5 stars

    Great idea, but required a little more "credit".

    • Written by from MOUNT DORA

    70 of 81 people found this useful

    I love Apple products and find their designs genius, beautiful and typically flawless. I never expected to run into such difficulty with installing the iMac 24" VESA Mount Adapter.

    This was my successful installation process and I hope it helps others who run into the same issue -- the holes at the end of the flange don't line up with the holes in the mount adapter.

    1. I removed the stand from my 24" iMac.
    2. I aligned the hole in the flange with the pin on the back of the iMac and attached it per the instructions.
    3. I placed the mount adapter on top of the flange and attempted to bolt the two pieces together. The bolts only spun. I then noticed the flange holes were too low and not aligned with the mount adapter holes.
    4. An Apple forum member suggested removing the rubberized strips from the mount adapter to lower it for better alignment. For protection, I placed a tissue under each "foot" and removed the excess afterwards.
    5. Removing the strips didn't lower the mount adapter enough. I discovered the iMac's locked assembly had some more play. I carefully held the iMac while pulling that assembly out of the back case as far as I could -- a distance that appeared to be just what I needed. Here's where the extra credit comes in.
    6. While holding the assembly in the extended position, I placed 3 credit cards underneath to keep it in that position.
    7. While pushing on the bolts with a little muscle, I was able to finally bolt the two pieces together and finish the installation. The credit went back in my wallet and the smile was back on my face. :-)

    Was this useful? Great idea, but required a little more "credit".

    Flag as inappropriate

  • 1.0 out of 5 stars

    SHAME!

    • Written by from Portland

    46 of 76 people found this useful

    This product is not up to Apple's usual and expected excellent standards. The big bracket does NOT align to the part they have you install in place of the stand -- the holes do NOT line up, it CANNOT be attached, a total waste of $39! BOOOOOO!

  • 1.0 out of 5 stars

    Buyer Beware! Does not properly fit 27" 2010 iMac

    • Written by from Glendale

    4 of 11 people found this useful

    There are other posts that refer to this problem and it is quite frankly shocking that it has not been acknowledged by Apple. In order to attach the Vesa mount, I had to jam 2-3 plastic cards (credit card shaped) beneath the Vesa flange to bring it high enough to attach the two final screws. Ridiculous. I wasted an hour or two trying to solve this problem, but thanks to the other reviewers was able to follow their lead and solve it.

    Buyer beware!

    Was this useful? Buyer Beware! Does not properly fit 27" 2010 iMac

    Flag as inappropriate